OpenScape CP200 - Rollover for a Line

74
Preview for a call
Press the "PreView" key. The key illuminates. The PreView function is temporar-
ily activated.
Press the flashing line key. A popup window opens and you receive information
about the caller. Press the line key again to accept the call or wait until the popup
closes itself after a specified period of time.
The preview function is switched off and has to be switched on again for a further
operation.
Permanent preview
Press the "PreView" key. The PreView for all lines with "Line preview" remains
active until you press the "PreView" key again.
Rollover for a line
Only the relevant line key flashes.
or
Z
You hear a special advisory tone via the currently active microphone and the
corresponding line key flashes.
or
Z
The ringer melody set sounds briefly (approx. 3 seconds) via the loudspeaker
and the corresponding line key flashes.
or
Z
You hear a short notification tone.
Z k
The phone rings. The corresponding line key flashes and a pop-up menu with
the available information is shown.
ñ
Your administrator has deactivated the permanent PreView function.
PreView
_
Line 1
£
ñ
Your administrator has deactivated the permanent PreView function.
PreView
_
If the PreView has been deactivated, a call is answered immediately on a
line when the line key is pressed, without first showing caller information.
ñ
Your administrator can determine how rollover calls are to be signaled.
Line 1
£
Line 1
£
Line 1
£
Line 1
£
The ringer melody is not played in speakerphone mode.
Line 1
£