OpenScape CP200 - Allowing Call Waiting

112
Allowing call waiting
z You can also configure this setting via the WEB-Oberfläche  page 132.
@ Press the key shown.
Select and confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Assuming Allow call waiting is activated, you can toggle a configured key to
switch call waiting on/off (
 page 60).
If the call waiting (second call) function is deactivated, a caller hears the
busy signal if you are already conducting a call.
ñ
The second call option was programmed by your administrator.
User
Configuration
Incoming calls?
Handling? f
Allow call waiting = No f
Yes l
Save & exit l