OPTIMUM
MASCHINEN - GERMANY
Safety
© 2008
GB
Page 114 February 2008 version 1.3.1 S210G; S275G; S210G Vario; S275G Vario Metal belt saw
1.8 Safety check
Check the metal belt saw at least once per shift. Inform the person responsible immediately of
any damage, defect or change in operating function.
Check all safety devices
• at the beginning of each shift (with the machine stopped),
• once a week (with the machine in operation),
• after every maintenance and repair operation.
Check that "Forbidden", Warning and Information labels and the markings on the metal belt saw
• can be identified (if not, clean them),
• are complete.
INFORMATION
Use the following table for checking.
1.9 Individual protection gear
For specific work, equipment for personal protection as protection equipment is required. This
includes:
• a safety helmet,
• protective goggles or face guard,
• safety gloves,
• safety shoes with steel toe cap,
• ear protection.
Before starting work check that the proper gear is available in the workplace.
CAUTION!
Dirty or contaminated body protection gear can cause disease.
Clean your individual protection gear
• each time after it has been used,
• regularly, at least once a week.
General check
Equipment Check OK
Protective covers Fitted, firmly bolted and not damaged
Labels, markings Installed and legible
Date: Checked by (signature):
Run test
Equipment Check OK
EMERGENCY button The metal belt saw must disconnect when the EMER-
GENCY button is activated.
Date: Checked by (signature):
To Next Page
Loading...
