OPTIMUM
MASCHINEN - GERMANY
Design and function
© 2008
GB
Page 274 February 2008 version 1.3.1 S210G; S275G; S210G Vario; S275G Vario Metal belt saw
4.9 Liquid cooling system
The sawing movement produces high tem-
peratures in the edge of the tool due to the
friction generated.
The tool must therefore be cooled during
operation. Using a suitable lubricant or
cooling agent leads to better results and
longer saw belt life.
Illustr.4-11: Cooling pump
INFORMATION
We recommend that you use a water-soluble and non-pollutant sawing emulsion as a cooling
agent. This can be acquired from authorised distributors.
Make sure to clean up the cooling agent after use.
Respect the environment when disposing of any lubricants and cooling agents.
Follow the manufacturer’s disposal instructions.
To Next Page
Loading...
