Optimum S210G - End Stop Switch; Pressure of the Saw Arch; Belt Guide Bearings

Design and function
OPTIMUM
MASCHINEN - GERMANY
© 2008
GB
Page 26 Metal belt saw S210G; S275G; S210G Vario; S275G Vario version 1.3.1 4 February 2008
4.6 End stop switch
The end stop switch disconnects the metal
belt saw in the bottom position.
Illustr.4-8: End stop switch
4.7 Pressure of the saw arch
The pressure of the saw arch is regulated
by means of a spring. The spring compen-
sates for the force.
If the pressure of the saw arch is badly set,
it can case curved cuts, breakage of teeth,
deformation, and breakage of the belt guide
pulleys.
Illustr.4-9: Spring
4.8 Belt guide bearings
ATTENTION!
The metal belt saws are designed for
use with the following saw belts.
• OPTI S 275 G
27 x 0.9 x 2480 mm
• OPTI S 210 G
20 x 0.9 x 2080 mm
Use of other saw blades could cause
damage to the saw.
Illustr.4-10: Belt guide bearings
End stop switch
Adjustable end stop
disconnectio
Spring
Screw
Screws