Appendix
OPTIMUM
MASCHINEN - GERMANY
© 2008
GB
Page 50 Metal belt saw S210G; S275G; S210G Vario; S275G Vario version 1.3.1 4 February 2008
9 Appendix
9.1 Copyright
© 2008
This document is copyright. All derived rights are also reserved, especially those of translation,
re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar means and
recording in data processing systems, whether partial or total.
The company reserves the right to make technical alterations without prior notice.
9.2 Terminology/Glossary
Term Explanation
Work piece
• Material to be sawed
Belt guide pulley
• Pulley through which the saw belt passes in
the saw arch
Saw arch
• Casing with protective cover for the saw
belt
Depth stop
• Position for multiple cuts
• Sawing stop
Hydraulic cylinder
• Hydraulic lowering cylinder
• Hydraulic feed
Feed regulation valve
• Valve on the hydraulic cylinder
Protective cover for
V-belt
• Protective cover of the V-belts
Protective cover for
saw arch
• Cover on the rear of the saw arch
Belt guide bearings
• Rollers between which the saw belt passes
and is guided
• Guide bearing
Saw belt guide
• Belt guide bearings
Saw belt brush
• Device for scraping off impurities
• Saw belt cleaning brush
Clamp
• Adjustable block on the work-holder vice
Work-holder vice
• Clamping device for the work piece
Helical gear
• Reduction gear from the drive motor to the
pulley for V-belt
Drive motor
•Motor
To Next Page