Control central and
paging desk
7. STARTING UP A DESK
To start up a DC-600ETH, proceed as follows:
1. By means of the P.A. Manager software, add the desk to the installation. Refer to section 7.1.
2. Configure the parameters of the desk. Refer to section 7.2.
3. Connect the unit to the installation structure. Refer to section 7.3.
4. Configure the IP address and make the connections. Refer to section 7.4.
5. Send configurations to the desk. Refer to section 7.5.
If the desk is already configured, connect it and when it starts up, it will already be operative.
a) If the installation has a Server PC, the desk will download the configuration variations from the Server
PC in the installation.
b) If the installation does not have a Server PC, on start-up the desk will use the configurations of its
local memory.
7.1. Configuration of the desk in the installation by means of the P.A.
Manager software
To configure the desk, it is necessary to have a PC connected to the network that has the SCF-01 or
SCM-01 (P.A. Manager) software.
1. If the software is the SCM-01, start the application, open the Options menu and select Installations
(administrator user level is required). If the software is the SCF-01, start the application.
NB: Prior to configuration of the desk parameters, it is necessary to have configured the parameters of the installation and the PA
areas.
2. From the installation screen, click on the PA area to which you wish to add the desk.
3. Open the Add Equipment menu and select DC600ETH/FC600ETH. The desk configuration window
appears.
4. Refer to section 7.2. Desk configuration parameters.
To Next Page
Loading...
