Control central and
paging desk
11.2. Basic operations in zone selection mode
11.2.1. Sending a live paging to a zone
1. Using the numeric keypad, enter the identifier
number of the zone where you wish to send
the announcement.
If you do not know the identifier number
corresponding to the zone where you wish to
send the announcement, press the key and
then OK. A list will appear with the name of
each of the zones. Use the navigation keys
/ to locate the required zone and press
OK.
To delete, use the DEL key.
2. Press and hold down GONG+TALK (or
TALK).
3. When the green TALK LED lights and TALK…
appears on the screen, you can begin to
speak.
4. To end the announcement, release
GONG+TALK (or TALK).
5. Press the navigation key to return to the
start screen.
11.2.2. Sending a live paging to a
group
1. Using the numeric keypad, press 0 and the
identifier number of the group where you wish
to send the announcement (groups always
begin with the number 0).
If you do not know the identifier number
corresponding to the group where you wish to
send the announcement, press the key and
then OK. A list will appear with the name of
each of the zones. Press once again and the
list of groups will appear. Use the navigation
keys / to locate the required group and
press OK.
To delete, use the DEL key.
2. Press and hold down GONG+TALK (or
TALK).
3. When the green TALK LED lights and TALK…
appears on the screen, you can begin to
speak.
4. To end the announcement, release
GONG+TALK (or TALK).
5. Press the navigation key to return to the
start screen.
11.2.3. Sending a live paging to
several zones and/or groups
1. Using the numeric keypad, enter the identifier
numbers of each of the zones or groups where
you wish to send the announcement,
separating each element by means of the
key (remember that the group identifier must
begin with 0).
If you do not know the identifier number
corresponding to a zone or group where you
wish to send the message:
1) Press the key and then OK. A list will
appear with the name of each of the zones.
Press the key once again and the list of
groups will appear. Using the and
keys, you can alternate between the list of
groups and the list of zones.
2) From any of the lists, use the navigation
keys / to select the element required
and press OK.
To delete, use the DEL key.
2. Press and hold down GONG+TALK (or
TALK).
3. When the green TALK LED lights and TALK…
appears on the screen, you can begin to
speak.
4. To end the announcement, release
GONG+TALK (or TALK).
5. Press the navigation key to return to the
start screen.
11.2.4. Sending a pre-recorded general
purpose message to zones or groups
1. Using the numeric keypad, enter the identifier
numbers of the zone or group where you wish
to send the message.
If you do not know the identifier number
corresponding to a zone or group, follow
points 1) and 2) in section 11.2.3.
To delete, use the DEL key.
2. Press or to position the cursor on the
MP3: line and proceed to select the pre-
recorded message.
3. Using the numeric keypad, enter the identifier
of the message that you wish to send. To send
several messages in a chain, enter the
identifiers of each message, separating each
element by means of the key.
To Next Page
Loading...
