Control central and
paging desk
ATTENTION:
The messages from the desk assigned to the WARNING
or EVACUATION buttons cannot be used as general
purpose messages.
11.4.5. Configuring the origin of the
WARNING and EVACUATION messages
(Requires Administrator user level).
The WARNING and EVACUATION messages can
be stored in the DC-600ETH desk or in the power
units of the OPTIMAX series.
If the desk is configured to store these
messages, when they are activated, they are
sent through the Ethernet connection to the
emergency group zones. If, on the other hand,
the configuration is such that the amplifiers
contain these messages, when they are
activated, the desk sends the order to the
amplifiers to play the message.
1. Press OK to access the main menu.
2. Select ADVANCED and press OK.
3. Select MESSAGES and press OK.
4. Select MESSAGES SOURCE and press OK.
5. Using the navigation keys /, select the
origin of the WARNING and EVACUATION
messages: PAGING DESK or ZONE.
6. Press OK.
7. Press the navigation key to return to the
start screen.
11.4.6. Configuring the WARNING and
EVACUATION button messages
(Requires Administrator user level).
Both the desks and the amplifiers in the OPTIMAX
series have two internal memories in which files
can be stored for subsequent use as pre-recorded
messages:
MP3 circuit memory, for files in MP3 format
Coldfire flash memory, for files in WAV format.
This configuration establishes which memory the
desk is to access in order to search for the
evacuation or warning message, and what the
content of each of these messages is.
1. Press OK to access the main menu.
2. Select ADVANCED and press OK.
3. Select MESSAGES and press OK.
4. Select WARNING PUSH-BUTTON MESSAGE
or EVACUATION PUSH-BUTTON MESSAGE.
5. Use the navigation keys / to select the
type of message that you wish to assign (MP3
or WAV) and press OK.
6. Use the navigation keys / to locate the
message that you wish to assign and press
OK.
7. Press the navigation key to return to the
start screen.
NB: If this option is not configured and there are
messages in the memory, message 1 in the MP3
memory of the desk is automatically assigned to
the EVACUATION button and message 2 in the
MP3 memory of the desk is assigned to the
WARNING button.
11.4.7. Assigning the Emergency
Group
(Requires Administrator user level).
This group will be the destination of the
messages whenever the desk goes into
Emergency Mode. To assign a group, the group
must first have been created by means of the
Group menu on the P.A. Manager software
installations screen.
If this is left unconfigured, the emergency
messages are sent to all the zones.
To configure this, proceed as follows:
1. Press OK to enter the main menu.
2. Press OK once again to enter the
EMERGENCY MODE menu.
3. Select EMERGENCY GROUP and press OK.
4. Use the navigation keys / to select the
group that you wish to assign and press OK.
5. Press the navigation key to return to the
start screen.
To Next Page
Loading...
