optris LaserSight - Configuring Alarms; High Temperature Alarm Setup; Low Temperature Alarm Setup

optris LS – E2006-01-A
12
High Alarm
Setting of a temperature value (alarm setpoint). If the temperature reading is
above this setpoint a visual display colour = red + flashing alarm symbol and
an acoustic signal [► Buzzer] will be generated:
Setting range: -35...900°C
Default setting: 900°C
HOLD⇒ II ⇒ I ⇒H flashes ⇒ Λ ⇒INCREASE VALUE
⇒ V ⇒DECREASE VALUE
⇒ II ⇒ACTIVATION/ DEACTIVATION⇒alarm symbol [beside H] on/ off
Low-Alarm
Setting of a temperature value (alarm setpoint). If the temperature reading is
below this setpoint a visual display colour = blue + flashing alarm symbol and
an acoustic signal [► Buzzer] will be generated:
Setting range: -35...900°C
Default setting: -35°C
HOLD⇒ II ⇒2x I ⇒L flashes ⇒ Λ ⇒INCREASE VALUE
⇒ V ⇒DECREASE VALUE
⇒ II ⇒ACTIVATION/ DEACTIVATION ⇒alarm symbol [beside L] on/ off