optris LS – E2006-01-A
17
If the Tamb-function is activated, the current set Tamb-value can be easily
displayed as follows:
Trigger+ Λ ⇒Toggle between Emissivity and Tamb in lower display
If, in addition, a thermocouple probe is connected, the lower display will toggle
between Emissivity,
t/c probe temperature
and Tamb value.
[► Thermocouple Probe]
Reset
With this function the unit can be set back to the factory default values
[► Factory Default Setting].
2. Menu⇒ II ⇒3 or 4
1)
x I ⇒RES⇒ II ⇒RES flashes ⇒ II ⇒RESET
⇒ I ⇒HOLD
⇒Trigger⇒Measure mode
1)
depends on the status of Tamb function
The stored values in the data logger will not be deleted with the reset function.
To Next Page
Loading...
