optris LaserSight - Device Setup: Comprehensive Settings; Emissivity and Alarm Configuration; Temperature Unit and Flip Mode Settings; Backlight, Buzzer, and Lock Mode Management

optris LS – E2006-01-A
32
Device Setup
The button Setup [Menu: Device\ Setup] opens a dialog
window for setting up the following parameters of the LS:
Emissivity Backlight
High alarm Laser
Low alarm Buzzer
Ext. Ambient Temp. Lock mode
Temperature unit Flip mode
The first activation of Ext. Ambient Temp. will initiate this
feature inside the LS unit. From this time the feature will
appear in the Setup Menu 2 on the unit, also if deactivated
again in the device setup [► Ambient Temperature Compensation].
A reset of the unit to the factory default values [► Reset] will delete the display of this function during operation
[Setup Menu 2].
To load the factory default settings into the unit please press the Factory Default button (same functionality as
► Reset). An additional query avoids a reset of the unit by mistake.
A change of parameters will be taken over from the connected unit immediatel
y
and vice versa.