Power On Oracle Database Appliance X3-2/X4-2/X5-2
138 Oracle Database Appliance Service Manual • February 2016
ODA X3-2 ODA X4-2 ODA X5-2
“Powering On Oracle Database
Appliance X3-2/X4-2/
X5-2” on page 138
“Powering On Oracle Database
Appliance X3-2/X4-2/
X5-2” on page 138
“Powering On Oracle Database
Appliance X3-2/X4-2/
X5-2” on page 138
Powering On Oracle Database Appliance X3-2/X4-
2/X5-2
When powering on the system, each server node is powered on separately.
Perform the following procedure to power on the Oracle Database Appliance.
Power On Oracle Database Appliance X3-2/X4-2/X5-2
This procedure describes how to restore power to Oracle Database Appliance X3-2/X4-2/X5-2
after servicing.
1.
If you powered off and disconnected the power cords from a storage shelf (and
storage expansion shelf if one is present), reconnect the power cords now.
2.
Power on the storage shelf (and storage expansion shelf if one is present) by
switching the power supply On/Off button on each power supply to the On
position.
The disks begin to initialize and the power supply LEDs light green. This can take several
minutes.
Note - Do not power on the server nodes until the disks on the storage shelf and storage
expansion shelf have initialized.
3.
If you powered off a server node, reconnect any unplugged power cords now.
4.
Power on a server node on using one of the following methods:
■
Press the recessed Power button on the server node front panel.
■
Log in to the Oracle ILOM web interface, click Host Management > Power Control, and
select Power On from the Select Action list box.
■
Log in to the Oracle ILOM command-line interface (CLI), and type the following command
at the Oracle ILOM CLI prompt.
-> start /SYS
When the server is powered on and the power-on self-test (POST) code checkpoint tests have
completed, the green Power/OK status indicator on the server node front panel lights and
remains lit.
To Next Page
Loading...
Need help?
General
