Oracle Database Appliance User Manual

Resetting the Service Processor
Chapter7 • Server Node Diagnostic Tools and Resetting the Service Processor 147
Note - Be sure to refer to the documentation that applies to the version of Oracle ILOM
supported with your appliance. See the "Supported Components and Capabilities" section in the
Oracle Database Appliance Owner's Guide.
If you are unable to reset the SP using the Oracle ILOM web interface or the CLI (for example,
if the SP hangs), then use the SP reset button as described in the following table.
ODA (Original Version) ODA X3-2 ODA X4-2 ODA X5-2
1. Find the SP reset
button on the rear of
the system, next to the
power supply and the
Locate button/LED.
See the "Oracle
Database Appliance
(Original Version)
Back Panel" section in
the Oracle Database
Appliance Owner's
Guide.
2. Insert a small stylus or
non-conductive object
into the opening and
press the recessed push
button switch.
The SP resets.
Reset the Service
Processor From the Server
Back Panel
Reset the Service
Processor From the Server
Back Panel
Reset the Service
Processor From the Server
Back Panel

Oracle Database Appliance Specifications

General

Product Type	Database Appliance
Form Factor	Rack-mountable
Storage Type	SSD
RAID Support	RAID 1, RAID 5, RAID 6, RAID 10
Storage Expansion	Yes
Maximum Disk Drives	Varies by model (e.g., 12, 18, 36)