Oracle Database Appliance User Manual

Oracle Database Appliance (Original Version) BIOS Utility
154 Oracle Database Appliance Service Manual • February 2016
BIOS POST Error Message Error Type Resolution
Uncorrectable Error Detected on Last Boot:IOH(0)
Miscellaneous Error (Please Check SP Log for more
Details)
IOH error ■ Press F1 to continue.
■ Check the fault management function and the SP
event log in Oracle ILOM for more details.
Uncorrectable Error Detected on Last Boot:IOH(0)
VTd Error (Please Check SP Log for more Details)
IOH error ■ Press F1 to continue.
■ Check the SP event log in Oracle ILOM for more
details.
BMC Not Responding Oracle ILOM error ■ Press F1 to continue.
Note - This error message might display if during
the SP/BIOS communication an internal error occurs.
This error might require you to restart the SP.
■ Primary Slave Hard Disk Error
■ Primary Master Hard Disk Error
■ Secondary Master Hard Disk Error
■ Secondary Slave Hard Disk Error
Note - These error messages are not supported on
Oracle Database Appliance.
IDE/ATAPI error ■ Press F1 to continue.
■ Check the SP event log in Oracle ILOM for more
details.
Note - These type of error messages display when the
BIOS is attempting to configure IDE/ATAPI devices
in POST.
Timer Error 8254 timer error ■ Press F1 to continue.
■ Check the SP event log in Oracle ILOM for more
details.
Note - This type of error typically indicates an error
while programming the count register of channel 2
of the 8254 timer. This could indicate a problem with
system hardware.
RAM R/W test failed Memory test failure ■ Press F1 to continue.
■ Check the SP event log in Oracle ILOM for more
details.
Note - This type of error typically indicates that the
RAM read/write test failed.
KBC BAT Test failed Keyboard controller basic
assurance test error
■ Press F1 to continue.
■ Check the SP event log in Oracle ILOM for more
details.
Note - Keyboard controller BAT test failed. This error
might indicate a problem with keyboard controller
initialization.
Display memory test failed Video display error ■ Press F1 to continue.
■ Check the SP event log in Oracle ILOM for more
details.
CMOS Battery Low CMOS battery error ■ Press F2 to enter BIOS Setup Utility to load
system defaults.
■ Check the SP event log in Oracle ILOM for more
details.
■ If necessary, replace CMOS battery.
■ CMOS Checksum Bad
■ CMOS Date/Time Not Set
CMOS error ■ Press F2 to enter BIOS Setup Utility to load
system defaults.

Oracle Database Appliance Specifications

General

Product Type	Database Appliance
Form Factor	Rack-mountable
Storage Type	SSD
RAID Support	RAID 1, RAID 5, RAID 6, RAID 10
Storage Expansion	Yes
Maximum Disk Drives	Varies by model (e.g., 12, 18, 36)