Power on the Server for the First Time
. . .
->
After a brief delay, the Oracle ILOM prompt is displayed (->).
Note - The server is provided with a default Administrator account (root) and a default
password (changeme) to enable first-time login and access to Oracle ILOM. To build a secure
environment, you must change the default password of the default Administrator account as
soon as possible after your initial login to Oracle ILOM. If you find this default Administrator
account has already been changed, contact your system administrator to obtain an Oracle ILOM
user account with Administrator privileges.
For more information about the administration tasks such as changing passwords, adding
accounts, and setting account privileges, refer to the Oracle ILOM documentation.
Note - By default, the SP is configured to use DHCP to obtain an IP address. If you plan
to assign a static IP address to the SP, see “Assign a Static IP Address to the NET MGT
Port” on page 66 for more instructions.
2.
Power on the server using one of the following methods:
■ Press the power button.
■ At the Oracle ILOM prompt, type:
-> start /System
Are you sure you want to start /System (y/n)? y
The server initialization might take several minutes to complete.
To cancel the initialization, press the #. (Hash+Dot) keys to return to the Oracle ILOM prompt.
Then type: stop /System
Note - In Oracle ILOM 3.1, the name space for /SYS was replaced with /System. You can use
the legacy name in a command at any time, but to expose the legacy name in the output, you
must enable it with -> set /SP/cli legacy_targets=enabled. For more information, see the
Oracle ILOM documentation.
3.
(Optional) Redirect the host output to display on the serial terminal device.
-> start /HOST/console
Are you sure you want to start /SP/console (y/n)? y
Serial console started.
. . .
56 SPARC T7-2 Server Installation Guide • March 2016
To Next Page
Loading...
Need help?
General