Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)
b.
For Script, type: setenv auto-boot? false
This setting configures the host to stop at the ok prompt instead of automatically booting
the preinstalled OS.
c.
Click Save.
Note - You have 10 minutes to perform the next step. After 10 minutes, the state is
automatically returned to normal.
5.
In the left navigation panel, click on Host Management > Power Control.
6.
Select Reset from the pull-down menu, and click Save.
7.
In the left navigation panel, click on Remote Control > Redirection.
8.
Select Use Serial Redirection, and click Launch Remote Console.
As the host resets, messages are displayed in the serial console. The reset activity takes a few
minutes to complete. When the ok prompt is displayed, continue to the next step.
9.
At the ok prompt, boot from the appropriate boot media for your installation
method.
For more information, refer to the Oracle Solaris installation guide that corresponds to your
desired release and installation method.
■
Installing Oracle Solaris 11 Systems, comparing installation options at:
http://www.oracle.com/goto/solaris11/docs
■
Oracle Solaris 10 Installation Guide: Planning for Installation and Upgrade, choosing an
Oracle Solaris installation method at:
http://www.oracle.com/goto/solaris10/docs
For a list of valid boot commands that you can enter at the OpenBoot prompt, type:
{0} ok help boot
boot <specifier> ( -- ) boot kernel ( default ) or other file
Examples:
boot - boot kernel from default device.
Factory default is to boot
from DISK if present, otherwise from NET.
boot net - boot kernel from network
boot cdrom - boot kernel from CD-ROM
boot disk1:h - boot from disk1 partition h
boot tape - boot default file from tape
boot disk myunix -as - boot myunix from disk with flags "-as"
62 SPARC T7-2 Server Installation Guide • March 2016
To Next Page
Loading...
Need help?
General