The columns under each tab are:
Event—This is the event that will trigger the notification. The events under
each tab will vary according to context.
Mask Alarm—Check here to enable an alarm mask. Enabling an alarm mask
for a given notification will prevent that notification from generating an alarm
condition. Other notifications for that event and logging of the event will still
occur.
SNMP Trap—Check here to configure the event to trigger an SNMP Trap.
Email—Check here to configure the event to trigger an email notification.
Email Address—Enter the address to which the email should be sent when
triggered by the event.
Note: Each event can be configured with the desired email address
that is specific to just that one event only. Note that only one email
address can be specified in each Email Address field.
For each event choose the notification you want and an email address – if any – to
which you want the notification to be sent. For more information, see "SNMP" on
page86 and "Setting Up Email Notifications" on page216.
For each event, only the notification options available can be configured. For
example, a mask alarm can be set for an In-Sync event, and a Not-in-Sync event, but
not for an In-Holdover event.
212
CHAPTER 4 • VersaSync User Manual Rev. 7.0
4.3 Notifications
To Next Page
Loading...