To Next Page

To Previous Page

Where eth0 is the base network port and eth1 (and higher) are used with the

optional Gigabit Ethernet module for multiple network interfaces.

User accounts with “user” group permissions can perform “get” commands but can-

not perform any “set” commands or change/reset passwords. Only user accounts

with “admin” group permissions can perform “set” commands or change/reset pass-

word. Refer to "Adding/Deleting/Changing User Accounts" on page220 for user

account setup information.

Command Description

clean Restores VersaSync configuration to factory defaults and reboots

cleanhalt Restores VersaSync configuration to factory defaults and halts

clearlogs Clears all logs

clearstats Clears all statistical data (NTP, and oscillator/disciplining)

dateget Displays current date (for example, 15 APR 2015)

dateset Used to set the current date

defcert Used to create a new Spectracom self-signed SSL certificate for HTTPS in case

of expiration of the original certificate

dhcp4get Displays whether DHCP is enabled

dhcp4set Used to enable or disable DHCP

dns4get Displays the configured DNS servers

dns4set Used to configure the DNS servers

dhcp6get Displays whether DHCPv6 is enabled

dhcp6set Used to enable or disable DHCPv6

doyget Used to obtain the current Day of Year

doyset Used to set the current Day of Year

gpsdop Displays GNSS receiver positional accuracy estimates

gpsdserviceportget Displays the GPSD service port

gpsdserviceportset Sets the GPSD service port

gpsinfo Applicable to SAASM-equipped VersaSync units only

gpsloc Displays GNSS latitude, longitude and antenna height

gpsmdl Displays the GNSS Manufacturer and Model

VersaSync User Manual 273

APPENDIX

Orolia VersaSync User Manual

Other manuals for Orolia VersaSync