MySets and Tools
57
7. Opacity
There are 4 degrees of opacity for display the histogram, waveform
and vectorscope on the screen. Set the transparency through the
Opacity
item.
100%: when opacity set to 100%, the assistant element
(histogram, waveform or vectorscope) is opaque, not
transparent.
75%: when opacity set to 75%, the assistant element (histogram,
waveform or vectorscope) is proportional to 75% opacity.
50%: when opacity set to 50%, the assistant element (histogram,
waveform or vectorscope) is proportional to 50% opacity.
25%: when opacity set to 25%, the assistant element (histogram,
waveform or vectorscope) is proportional to 25% opacity.
For example:
set
Histogram
Opacity
as 100%, 75%, 50%, 25%
separately, the comparisons are as below:
To Next Page
Loading...
