Operation
44
DTX-2200-3000 AC/DC
2200 AC/DC 3000 AC/DC
TIG DC 5 - 220 A 5 - 300 A
TIG
AC
DYNAMIC TIG
SPEED TIG
COLD TIG
SOFT TIG
5 - 220 A
5 - 220 A
16 - 127 A
16 - 156 A
5 - 300 A
5 - 300 A
5 - 173 A
5 - 212 A
2200 AC/DC - 3000 AC/DC
TIG DC 0,01 - 0,99 sec
TIG
AC
0,10 - 0,99 sec
SLOW PULSE
TIG pulse welding with manual setting of parameters.
WARNING: This can only be programmed when the 3 TIG welding processes are used.
Press the PULSE key (T5) until the requited pulsation is active.
Press the WELDING PARAMETERS SELECTION key (T10) a number of times to set the following (in addition to
the WELDING PARAMETERS defined as being “BASIC”):
L21 PEAK CURRENT I
p
L20 BASE CURRENT I
b
L15 PEAK current
duration
T
p
2200 AC/DC 3000 AC/DC
TIG DC 5 - 220 A 5 ÷ 300 A
TIG
AC
DYNAMIC TIG
SPEED TIG
COLD TIG
SOFT TIG
5 - 220 A
5 - 220 A
16 - 127 A
16 - 156 A
5 - 300 A
5 - 300 A
5 - 173 A
5 - 212 A
To Next Page
Loading...
