Operation
49
DTX-2200-3000 AC/DC
2200 AC/DC 3000 AC/DC
TIG DC 5 - 220 A 5 - 300 A
TIG
AC
DYNAMIC TIG
SPEED TIG
COLD TIG
SOFT TIG
5 - 220 A
5 - 220 A
16 - 127 A
16 - 156 A
5 - 300 A
5 - 300 A
5 - 173 A
5 - 212 A
2200 AC/DC - 3000 AC/DC
TIG DC 0,01 - 0,99 sec
TIG
AC
0,10 - 0,99 sec
L19 2
nd
LEVEL PEAK CURRENT I
2p
L20 1
st
LEVEL BASE CURRENT I
1b
L15 PEAK current
duration T
p
L14 BASE current
duration T
b
To exit the setting phase, hold the WELDING PARAMETERS SE- LECTION key (T10) down for about 1
second
.
FAST PULSE +
Bi-Level
Press the PULSE key (T5) until the requited pulsation is active (FAST LED on).
Press the WELDING MODE SELECTION key (T9) until the Bi- Level welding mode is active (Bi-Level LED on).
Press the WELDING PARAMETERS SELECTION Key (T10) a number of times to set the following (in addition to
the WELDING PARAMETERS defined as being “BASIC”):
2200 AC/DC 3000 AC/DC
TIG DC 5 - 220 A 5 - 300 A
TIG
AC
DYNAMIC TIG
SPEED TIG
COLD TIG
SOFT TIG
5 - 220 A
5 - 220 A
16 - 127 A
16 - 156 A
5 - 300 A
5 - 300 A
5 - 173 A
5 - 212 A
2200 AC/DC - 3000 AC/DC
TIG DC 0,01 - 0,99 sec
TIG
AC
0,10 - 0,99 sec
To Next Page
Loading...
