Owon HDS series User Manual

OWON HDS Series Handheld DSO & DMM 6-Using the Scope
6.15 Selecting AC-coupling
After a reset, the Oscilloscope is dc-coupled so that ac and dc voltages appear on the screen, Use
ac-coupling when you wish to observe a small ac signal that rides on a dc signal. To select
ac-coupling, do the following:
1. Press MENU key and the function menu appears at the right side of the screen.
2. Press MENU ▲ or MENU ▼ key to select the CH1 Setting. Four items selectable are
visible at the bottom of the screen.
3. Press the F1 key and jump to AC. The bottom left side of the screen displays the
ac-coupling icon.
Now, you can see a screen that looks like the following figure 17.
figure 17: AC-Coupling
6.16 Reversing the Polarity of the Displayed Waveform
To invert the input CH1 waveform, do the following:
1. Press the MENU key and the function menu appears at the right side of the screen.
2. Press the MENU ▲ or MENU ▼ key to select CH1 setting. Four items selectable are
displayed at the bottom of the screen.
3. Press F4 key to jump to Inverted. The inverted waveform of CHI1 is displayed on the
screen.
22

Owon HDS series Specifications

General

Channels	2
Bandwidth	Up to 100 MHz
Multimeter Functions	Voltage, Current, Resistance, Capacitance
Resistance Measurement Range	400Ω ~ 40MΩ
Power Supply	Lithium Battery
Connectivity	USB
Battery Life	About 6 hours
Weight	Approx. 500 g
Duty Cycle Range	0.1% to 99.9%
Data Storage	Internal memory
Voltage Measurement Range	400mV ~ 1000V
Current Measurement Range	0.1 μA to 10 A