Panasonic AAD03011 - Operation Status Monitor (R146); Output Terminal State Monitor (R145); Input Terminal State Monitor (R144)

R1450 RY1 output signal
R1451 RY2 output signal
R1452 RY3 output signal
1: RY output signal is ON (energized).
0: RY output signal is OFF (not energized).
䃂 Output terminal state monitor(R145ƶ)
It indicates the output states of RY output terminal.
䃂㩷Input terminal state monitor (R144ƶ)
It indicates the states of the control terminals No. 1 to 7 and phase A and B of the encoder input.
Relay No. Name Details
Relay No. Name Details
Relay No. Name Details
R1440 OPEN signal input state
R1441 CLOSE signal input state
R1442 OPEN arrival signal input state
R1443 CLOSE arrival signal input state
R1444 Safety sensor signal input state
R1445 OPEN speed change input state
R1446 CLOSE speed change input state
R1447 Encoder phase A signal input state
R1448 Encoder phase B signal input state
1: Terminal is ON (closed).
0: Terminal is OFF (opened).
䃂㩷Operation status monitor(R146ƶ)
It indicates the operation status of the inverter.
R1460 Run signal (RUN)
1: Runs
0: Stops
R1461 Reverse run signal (REV)
1: Reverse operation runs.
0: Stops or forward operation runs.
R1462 Arrival signal(FR-ARV)
R1463 Overload alarm (OL)
R1464 OPEN arrival signal (OP-ARV)
R1465 CLOSE arrival signal (CL-ARV)
R1466 Obstacle detection signal
1: It is turned ON.
0: It is turned OFF.
R146F Fault alarm
1: Fault state
0: Normal state
81