Panasonic AAD03011 - Explanation of Control Circuit Terminals

䂓 Explanation of Control Circuit Terminals
Terminal
No.
Terminal Function
Related Parameter
No.
Ԙ
Input terminal of Open Signal
(forward run operation)
P08
ԙ
Input terminal of Close Signal
(reverse run operation)
P08
Ԛ
Input terminal of Open arrival signal
ԛ
Input terminal of Close arrival signal
Ԝ
Input terminal of safety sensor
P43,P44
ԝ
Input terminal of Open speed change signal
Ԟ
Input terminal of Close speed change signal P09,P43,d50
P09,P46,P52
P09,P46,P52
ԟ
Common terminal of input signal 1 to 7

Ԡ

ԡ
Input terminal of encoder (phase A) signal
Ԣ
Input terminal of encoder (phase B) signal
ԣ 
A 1
Relay 1 contact output terminal (NO: at factory setting)
P48
B 1
Relay 1 contact output terminal (NC: at factory setting)
P48
C 1
Relay 1 contact output terminal (COM) P48
A 2
Relay 2 contact output terminal (NO: at factory setting) P49
B 2
Relay 2 contact output terminal (NC: at factory setting) P49
C 2
Relay 2 contact output terminal (COM) P49
A 3
Relay 3 contact output terminal (NO: at factory setting) P50
B 3
Relay 3 contact output terminal (NC: at factory setting) P50
C 3
Relay 3 contact output terminal (COM) P50
D㧗
Transmission line + terminal
(RS485 serial communication signal)
P35 to P40
D㧙
Transmission line - terminal
(RS485 serial communication signal)
P35 to P40
E
Terminal for setting terminator
(Transmission line- terminal and short-circuit)
Do not short the units other than the terminator.

V㧗
Unused terminal

V㧙
Unused terminal

20
P43,P45,P47,P76,
d49
P09,P43,d48
P43,P45,P47,P76,
d47
Built-in power supply (+) terminal (12 V DC)
Built-in power supply (-) terminal (12 V DC
common terminal)