14
Weekly Timer
Add new timer
Set time
Set conditions
Edit timer
Off / On timer
Add new timer
Edit Timer
Copy timer
Select temperature
Off / On
Troubleshooting
When the power LED does not light up
(no power supply to the adaptor)
Check the power supply.
Check the connection of the cable.
When the status LED does not light up
(Adaptor can’t communicate with air-conditioner)
Check the connection of the cable.
The connection between your device and a client through wireless network
cannot be established.
Ensure that the wireless network function is enabled.
Refresh the network list and select the correct SSID.
Check the IP address, and ensure that your client can automatically obtain
an IP address.
Enter the correct network key (wireless network password) when you connect
with AP mode.
Reset device Password
(In case you forgot the device Password)
Remove the device from device list and add back the device.
Factory reset the device and add back the device. The device factory reset
can be done by press and hold CHECK and SETUP button for 10 seconds.
After release the CHECK and SETUP button, press the reset button.
STATUS
LINK
POWER
Select mode
To Next Page
Loading...
