8.1.6 Output File
The output image file name is as follows.
Prefix
Item
delimiter
Type Code
Item
delimiter
Sequence
ID
*1
Dot Extension
1 to 15
characters
*2
1 character 1 character 1 character
5
characters
*3
1 character 3 characters
Example
Panasonic_
DOC01
-
M
-
00001
.
jpg
*1
If a Factory Reset is performed on the unit, the Sequence ID that is applied to file names pushed to all destinations will also be
reset. Therefore, you should assign a different folder path from the existing one to prevent existing data from unexpectedly being
overwritten.
*2
Up to 31 characters if [Location] is selected. Up to 94 characters if [Combination] is selected. Up to 63 characters if [Manual
Input] is selected.
*3
6 characters when "Common File Counter" (page 79) is set to "On".
• When "Suffix Removal" (page 102) is set to "On", "Item delimiter", "Type Code" and "Sequence ID" are
not displayed.
Prefix
Type of prefix Number of characters Contents
Host Name 3 to 15
Set the value of "Network
Setting" in "IP Configuration"
(page 105).
Date and Time 14
The format set in [Date & Time]
(page 98).
• YYYYMMDDhhmmss
• MMDDYYYYhhmmss
• DDMMYYYYhhmmss
User Name 1 to 15 User authentication name.
*1
User-defined Field 1 to 15
Set the value of "File Name" in
"Scan Settings" (page 101).
Location 1 to 31
Set the value of "Network
Setting" in "IP Configuration"
(page 105).
Combination 1 to 94
The following contents can be
combined. Set the value of "File
Name" in "Scan Settings" (page
101).
• Host Name
• Date and Time
• User Name
• User-defined Field
• Location
8.1.6 Output File
77
To Next Page
Loading...
