Panasonic KX-HDV100 - Stutter Tone; Tone Frequencies; Tone Timings; Reorder Tone

4.6.5.4 Stutter Tone
Tone Frequencies
Description Specifies the dual-tone frequencies, in hertz, of stutter dial tones to
notify
that a voice mail is waiting, using 2 whole numbers separated by
a comma.
Value Range 0, 200–2000 (0: No tone)
Note
• If
the value for this setting is "350,440", the unit will use a mixed
signal of a 350 Hz tone and a 440 Hz tone.
Default Value 350,440
Configuration File Reference DIAL_TONE4_FRQ (Page 248)
Tone Timings
Description Specifies the pattern, in milliseconds, of stutter dial tones to notify that
a
voice mail is waiting, using up to 22 whole numbers (off 1, on 1, off 2,
on 2…) separated by commas.
Note
• It is recommended that you set a value of 560 milliseconds or
more for the first value (off 1).
Value Range 0–16000 (0: Infinite time)
Note
• Avoid setting 1–50 for any of the values.
Default Value 560,100,100,100,100,100,100,100,100,100,100,100,100,100,100,10
0,100,100,100,100,100,0
Configuration File Reference DIAL_TONE4_TIMING (Page 248)
4.6.5.5 Reorder Tone
Tone Frequencies
Description Specifies the dual-tone frequencies, in hertz, of reorder tones using 2
whole numbers separated by a comma.
Value Range 0, 200–2000 (0: No tone)
Note
• If
the value for this setting is "480,620", the unit will use a mixed
signal of a 480 Hz tone and a 620 Hz tone.
Default Value 480,620
Configuration File Reference REORDER_TONE_FRQ (Page 250)
Document Version 2015-02 Administrator Guide 133
4.6.5 Tone Settings