2.4 PBX Configuration—[3] Trunk
2.4.1 PBX Configuration—[3-1] Trunk—Port
Description
Settings can be made for each trunk port. Click the "Edit" button located next to the trunk number to enable
editing of the setting values.
Screen / Tab Setting item Description Input Type Note
1.Port-Main Attribution Selects the attributes of a trunk
port.
Select
Trunk Group Specifies the trunk group
number to which the trunk
belongs.
Select
1.Port-Analog -
Basic
Dialing Mode Selects the type of signal used
to dial out to the analog trunk.
Radio
Caller ID Detection Enables the PBX to detect a
Caller ID signal from the
analog trunk.
Radio
Caller ID Detection
Pattern
Selects the type of Caller ID
signaling provided by the
telephone company.
Radio
Reverse Detection Selects the type of trunk call
for which the reverse signal
from the telephone company is
detected.
Radio
1.Port-Analog -
CPC Detection
CPC Signal Detection
Time Outgoing
Specifies the length of time
required by the PBX to detect a
CPC signal on outgoing trunk
calls before disconnecting the
line.
Select
CPC Signal Detection
Time Incoming
Specifies the length of time
required by the PBX to detect a
CPC signal on incoming trunk
calls before disconnecting the
line.
Select
1.Port-Analog -
DISA
DISA Tone Detection -
Silence
Enables the disconnection of a
DISA-originated trunk-to-trunk
call by silence detection.
Radio
DISA Tone Detection -
Continuous
Enables the disconnection of a
DISA-originated trunk-to-trunk
call by continuous signal
detection.
Radio
DISA Tone Detection -
Cyclic
Enables the disconnection of a
DISA-originated trunk-to-trunk
call by cyclic signal detection.
Radio
2.4 PBX Configuration—[3] Trunk
38 Programming Item List
To Next Page
Loading...
