Destination Availability
PS
ü
*1
ICD Group
ü
SIP Extension
PS Ring Group
Floating Extension no. for SVM
VM Group (DTMF/DPT)
External Pager (TAFAS)
DISA
Analog/ISDN Remote Maintenance
Idle Line Access no. + Phone no.
Trunk Group Access no. + Trunk Group no. + Phone no.
Extension of Another PBX (via TIE Line, Access with PBX Code)
Extension of Another PBX (via TIE Line, Access without PBX Code)
*1
A PS destination can be used to forward fax calls to a fax machine at another PBX connected by TIE line.
A virtual PS can
be specified as the destination of fax calls. Then, the extension number of the fax machine at the other PBX can be
specified as the FWD—ALL Calls destination for calls to that virtual PS. (® 19.1.2 Virtual PS)
Conditions
• Hardware Requirement:
An OPB3 card and ESVM4 card
• When using this feature, it is necessary to disable the MSG Feature setting of the MPR card.
• This feature is only effective for calls arriving on DISA lines.
• If a fax signal is not detected before the DISA Intercept Routing—No Dial timer expires, the call is redirected
to the operator extension, and fax detection ends.
• It is not recommended to use the CNG feature when an MSG card is installed in the PBX.
Installation Manual References
KX-NCP500/KX-NCP1000
3.7.1 OPB3 Card (KX-NCP1190)
3.7.5 MSG4 Card (KX-TDA0191)
3.7.6 ESVM4 Card (KX-TDA0194)
KX-TDE100/KX-TDE200
3.7.1 OPB3 Card (KX-TDA0190)
3.7.5 MSG4 Card (KX-TDA0191)
3.7.6 ESVM4 Card (KX-TDA0194)
KX-TDE600
3.9.1 OPB3 Card (KX-TDA0190)
3.9.4 MSG4 Card (KX-TDA0191)
3.9.5 ESVM4 Card (KX-TDA0194)
24 Feature Manual Document Version 2013-05
1.1.6 Automatic Fax Transfer
To Next Page
Loading...
