1.21 Administrative Information Features
156 Feature Guide
Number in the
Pattern
Data Description
(1) Date Shows the date of the call.
(2) Time Shows the end time of a call as hour/minute/AM or PM.
(3) Ext (Extension) Shows the extension number, floating extension number, etc.,
which was engaged in the call.
Also shows the following codes:
Dxxx: Outgoing CO line call from a doorphone
(xxx=doorphone number) (→ 1.15.1 Doorphone Call)
*xxx: Verified call (xxx=verified code) (→ 1.8.5 Verified Code
Entry)
(4) CO Shows the CO line number used for the call.
(5) Dial Number [CO Line Call]
Outgoing CO Line Call
Shows the dialed telephone number.
Digits shown are as follows:
0 through 9, , #
P: Pause
F: External Feature Access (EFA) signal
=: Host PBX Access code (→ 1.5.4.6 Host PBX Access Code
(Access Code to the Telephone Company from a Host PBX))
. (dot): Secret dialing
–: Transferred call
If the transfer destination extension enters additional digits,
those digits will be added after "–".
Incoming CO Line Call
Shows <I> + the caller's identification name/number.
[Outgoing Intercom Call]
Shows the dialed extension number followed by "EXT".
[Log-in/Log-out]
Shows the Log-in or Log-out status.
[Timed Reminder]
Shows the status of a timed reminder, either "Start", "No
Answer", or "Answer". (→ 1.23.4 Timed Reminder)
[Printing Message]
Shows the selected message. (→ 1.21.2 Printing Message)
[Sensor Call]
Shows calls from an external sensor as follows:
<I> S + sensor number. (→ 1.15.8 External Sensor)
(6) Ring Shows the ring duration before the call was answered in
minutes/seconds.
(7) Duration Shows the duration of the CO line call in hours/minutes/
seconds.
(8) Acc Code
(Account Code)
Shows the account code appended to the call. (→ 1.5.4.3
Account Code Entry)
To Next Page
Loading...
