1.10 Conversation Features
86 Feature Guide
• Disconnect Time (Only for Flash/Recall Mode)
The amount of time between successive accesses to the same CO line is programmable for each CO
line port (→ LCOT Disconnect Time [418]).
• This feature generates a Station Message Detail Recording (SMDR) call record (→ 1.21.1 Station
Message Detail Recording (SMDR)), restarts the call timer, inserts a pause, and checks the Toll
Restriction (TRS) level (→ 1.8.1 Toll Restriction (TRS)) again.
• If Automatic Route Selection (ARS) is used (→ 1.9.1 Automatic Route Selection (ARS)) or if a CO line
call is established using the INTERCOM button or G-DN button, Terminate mode will be effective even
when Flash/Recall mode has been set.
Feature Guide References
1.18.2 Flexible Buttons
1.10.6 External Feature Access (EFA)
Description
An extension user can access features of a host PBX or the telephone company, such as Transfer, Hold,
Call Waiting, etc. A flash/recall signal is sent to the host PBX or the telephone company. This is only
available on CO line calls, including Host PBX Access (→ 1.5.4.6 Host PBX Access Code (Access Code to
the Telephone Company from a Host PBX)).
Conditions
• Flash/Recall Time
The Flash/Recall time can be assigned for each CO line port (→ LCOT Flash/Recall Time [417]).
• EFA Button
A flexible button can be customized as the EFA button.
• This feature is accessed by pressing the FLASH/RECALL button which is set to EFA mode (→ 1.10.5
Flash/Recall/Terminate) or the EFA button. It is also possible to perform this feature by entering the
feature number when the current call is placed on a consultation hold (→ 1.12.5 Consultation Hold).
Feature Guide References
1.18.2 Flexible Buttons
User Manual References
1.9.4 Host PBX
1.10.7 CO Line Call Limitation
Description
CO Line calls are limited by the following features:
To Next Page
Loading...
