1.10 Conversation Features
Feature Guide 85
the second call by placing the current call on hold. Pressing the Release button enables one to
disconnect the line during or after conversation, or to complete a Call Transfer.
Feature Guide References
1.18.2 Flexible Buttons
User Manual References
1.3.5 Answer/Release Button
1.4.7 Headset Operation
3.1.2 Settings on the Programming Mode
1.10.4 Data Line Security
Description
Once Data Line Security is set on an extension, communication between the extension and the other party
is protected from signals such as Call Waiting, Hold Recall and Executive Busy Override. Extensions which
have devices connected to them such as modems or fax machines may set this feature to maintain secure
data transmission, by blocking tones or other interruptions during communication.
User Manual References
1.7.6 Data Line Security
1.10.5 Flash/Recall/Terminate
Description
A proprietary telephone (PT) user can use the FLASH/RECALL button (Flash/Recall mode or Terminate
mode) or Terminate button (Terminate mode) to disconnect the current call and originate another call without
hanging up.
Flash/Recall Mode: Disconnects the line and the extension user hears the dial tone from the line used last.
For example, if a CO line call is disconnected, the extension user will hear a new dial tone from the same
CO line.
Terminate Mode: Disconnects the line and the extension user hears a dial tone via the preferred CO line.
(→ 1.5.5.2 Line Preference—Outgoing)
Conditions
• FLASH/RECALL Button Mode
One of the following modes can be selected for each extension through system programming:
– Flash/Recall mode
– Terminate mode
– EFA mode. (→ 1.10.6 External Feature Access (EFA))
• Terminate Button
Any flexible button can be customized as the Terminate button.
To Next Page
Loading...
