1.1 Incoming Call Features
Feature Guide 19
[Available Intercept Destination]
The following can be used as intercept destinations:
Conditions
• If the intercept destination is busy or in DND mode and therefore cannot receive the call:
a) When the call was intercepted via Intercept Routing—No Answer, the call is sent back to the
original destination and continues to ring at the original destination until answered.
b) When the call was intercepted via Intercept Routing—Busy, the call waits at the original
destination. If the extension has Call Waiting activated, the user will hear a call waiting tone.
c) When the call was intercepted via Intercept Routing—DND, the call waits at the original destination
and it rings.
• PS Ring Group
• VM Group (DTMF/DPT)
• External Pager (TAFAS)
The destination assigned to the CO line group
carrying the call (→ CO Line Group Intercept
Destination [470])
• DISA The destination assigned to the CO line group
carrying the call* (→ CO Line Group Intercept
Destination [470])
• Analog Remote Maintenance
• Idle Line Access no. + Phone no.
• CO Line Group Access no. + CO Line Group
no. + Phone no.
Not assignable (Intercept Routing is not available.)
* Intercept Routing will redirect a call only if the Direct Inward System Access (DISA) line is busy. Once
a call reaches the destination extension using the DISA feature, the call can be redirected to the
Intercept Routing destination assigned to that extension.
Intercept Destination Availability
Wired Extension (PT/SLT)
PS
ICD Group
PS Ring Group
VM Group (DTMF/DPT)
External Pager (TAFAS)
DISA
Analog Remote Maintenance
Idle Line Access no. + Phone no.
CO Line Group Access no. + CO Line Group no. +
Phone no.
When the original destination is: The Available Intercept Destination is:
To Next Page
Loading...
