Panasonic KX-TDA30

1.18 Caller ID Features
228 Feature Guide
3.3 Caller's Name Reference
A name can also be shown on the display or SMDR. The PBX searches for the name in the
following order:
1) Personal Speed Dialling data of the original called extension
2) System Speed Dialling (Caller ID) Table
3) Caller ID name received from the public line (Caller ID Name Reference)
If the name is not found, it will not be displayed.
Conditions
[General]
• Caller ID signalling type can be selected through system programming.
• The Caller ID Name Reference is only available for calls from the public network.
[Caller ID to SLT Port]
• Hardware Requirement:
KX-TDA30: An EXT-CID card
KX-TDA100/KX-TDA200: An SLC8 card with an EXT-CID card installed, or a CSLC16 card
KX-TDA600: An SLC8 card with an EXT-CID card installed
• This feature complies with ETSI (European Telecommunications Standards Institute)-type FSK and
Bellcore-type FSK.
• KX-TDA30 only
Through system programming, a group of four SLT or Super Hybrid ports can be assigned to receive
Caller ID. Up to two groups can be programmed. Therefore, a maximum of eight SLTs can receive
Caller ID.
Note that SLTs connected in parallel to DPTs attached to Super Hybrid ports can only receive Caller ID
information when set to "ring" mode.
• When the caller's number is sent to an SLT, a Trunk Access number can be automatically added to the
telephone number through system programming for calling back.
• When the caller's number exceeds 16 digits, the SLT receives only the first 16 digits, not counting the
preceding Trunk Access number (if it is programmed to be added).
• If a call is transferred to an SLT, the transferring extension's information will be shown on the SLT. If the
transferring extension goes on-hook before the call is answered, the original caller's information will be
shown.
• When the Caller ID has information, such as private, out of area, or long distance, the information will
be shown instead of the caller's number and name.
• Even if the caller's name is sent, the name may not be shown depending on the type of SLT.
• Incoming Call Log information is not shown on the SLT.
Programming Manual References
PC Programming Manual
*1
:
→ 2.12.1 [6-1] System Speed Dial—CO Line Access Number + Telephone Number
→ [001] System Speed Dialling Number
*2
:
→ 2.12.1 [6-1] System Speed Dial—Name
→ [002] System Speed Dialling Name
*3
:
→ 2.12.1 [6-1] System Speed Dial—CLI Destination