Panasonic KX-TDA30

1.24 Voice Mail Features
Feature Guide 279
→ 2.9.19 [3-8-1] VM(DTMF) Group—System Settings—Others—Intercept Routing to the VPS
Sequence
[Example of a) & b)]
c) Transferring to a Mailbox of the VPS
An extension user can transfer a call to a mailbox of the VPS so that the caller can leave a message
in the mailbox of the desired extension. (→ 1.12.1 Call Transfer) The extension user should use the
Voice Mail (VM) Transfer button, when transferring a call to the mailbox of the VPS. When the
extension user presses this button and enters the desired extension number, the PBX will transfer
the call to the VM group and dial the mailbox number of the desired extension with the required
command (after the VPS answers the call). Therefore the caller can leave a message without
knowing the mailbox number.
2.10.5 [4-1-4] Wired Extension—Flexible Button
→ Ty pe
→ Ext. No. / Floating Ext. No. (for Voice Mail Transfer)
2.10.10 [4-2-1] Portable Station—Extension Settings
→ Ty pe
→ Ext. No. / Floating Ext. No. (for Voice Mail Transfer)
2.10.17 [4-3] DSS Console—Flexible Button
→ Ty pe
→ Ext. No. / Floating Ext. No. (for Voice Mail Transfer)
Parameter
Transmitted Command
In AA Service Mode In VM Service Mode
Answer by Mailbox Switching to VM command +
Recording message command (#6
+ H [H = Mailbox No.])
Recording message command (H
[H = Mailbox No.])
AA Switching to AA command (#8) Switching to AA command (#8)
None (Default) (DTMF commands are not sent. Work with default of the VPS.)
Trunk Call
Operator
Extn. 102
VM Port 1 VM Port 2
VM Port X
VM Port 3
VM (DTMF)
Group
VPS (In AA service mode)
FWD, Intercept
PBX
Transfer
Sent "#6" + "102".
Switching to VM command
mailbox number