Panasonic KX-TDA30

1.26 Administrative Information Features
Feature Guide 305
(3) Ext (Extension) Shows the extension number, floating extension number, etc.,
which was engaged in the call.
Also shows the following codes:
Dxxx: Outgoing trunk call from a doorphone (xxx=doorphone
number) (→ 1.17.1 Doorphone Call)
Txxx: Outgoing trunk call by TIE line service (xxx=trunk group
number)
*xxx: Verified call (xxx=verification code) (→ 1.9.6 Verification
Code Entry)
(4) CO (Trunk) Shows the trunk number used for the call.
For patterns A and B, "00" will be shown for trunk numbers over
hundred.
(5) Dial Number [Trunk Call]
Outgoing Trunk Call
Shows the dialled telephone number.
Valid digits are as follows:
0 through 9, , #
P: Pause
F: EFA signal
=: A Host PBX Access code (→ 1.5.4.8 Host PBX Access Code
(Access Code to the Telephone Company from a Host PBX))
. (dot): Secret dialling
X: Privacy dial
–: Transferred call
If the transfer destination extension enters some digits, the entered
digits will be added after "–".
Incoming Trunk Call
Shows <I> + the caller's identification name/number.
It is also possible to show the DDI/DID/MSN call information. In this
case, <D> + DDI/DID/MSN name/number is added before <I> .
[Outgoing Intercom Call]
Shows the dialled extension number followed by "EXT".
[Log-in/Log-out]
Shows the log-in or log-out status.
[Check-in/Check-out]
Shows the check-in or check-out status. (→ 1.27.2 Room Status
Control)
[Timed Reminder]
Shows the status of a timed reminder, either "Start", "No Answer",
or "Answer". (→ 1.28.4 Timed Reminder)
[Printing Message]
Shows the selected message. (→ 1.26.2 Printing Message)
[Sensor Call]
Shows calls from an external sensor as follows:
<I> S + sensor number. (→ 1.17.9 External Sensor)
Number in
the Pattern
Item Description