146
SQW0038
Shutter and Drive Settings
Recording while exposure is changed automatically [Auto Bracket]
■
Changing the Single/Burst setting, compensation range, and recording sequence
of Auto Bracket
Set the menu
→ [Rec] → [Auto Bracket]
Press to select [Single/Burst Settings], [Step] or [Sequence] and press
[MENU/SET]
Press to select the setting and press [MENU/SET]
[Single/Burst
Settings]
(single)
(burst)
[Step]
3·1/3 (3 pictures)
3·2/3 (3 pictures)
3·1 (3 pictures)
5·1/3 (5 pictures)
5·2/3 (5 pictures)
5·1 (5 pictures)
7·1/3 (7 pictures)
7·2/3 (7 pictures)
7·1 (7 pictures)
[Sequence]
0/–/+
–/0/+
• You can take one picture at a time when [
] is set.
• A burst of pictures can be recorded up to the number of pictures you have set when [
] is set.
• Close the menu after changing settings.
●
When you take pictures using Auto Bracket after performing Exposure Compensation, the camera
will take pictures using the corrected exposure value as a reference.
Not available in the following cases:
●
The [Auto Bracket] is disabled in the following cases:
• When the picture effect (Filter) is set ([Rough Monochrome], [Silky Monochrome],
[Miniature Effect], [Soft Focus], [Star Filter], [Sunshine])
• When White Balance Bracket is set
• During motion picture recording
• When [4K PHOTO] is set to [ON]
• When recording using the flash
• During T (time) recording
• When [HDR] is set to [ON]
• When [Multi Exp.] is set
• When using [Time Lapse Shot]
• When using [Stop Motion Animation] (only available with [Auto Shooting] setting)
• When [Simultaneous record w/o filter] is set to [ON]
To Next Page
Loading...
