241
SQW0038
Wi-Fi
Operating the camera by connecting it to a smartphone
[Send Images Stored in the Camera]
1
Set the menu
→ [New Connection] → [Send Images Stored in the Camera]
→ [Smartphone]
2
Select [Via Network] or [Direct] and press [MENU/SET]
■
When connecting with [Via Network]
(On the camera)
Connect the camera to a wireless access point (→264)
(On your smartphone)
Set Wi-Fi function to “ON”
Select the wireless access point you connected to the camera, and set
Start “Image App” (→228)
■
When connecting with [Wi-Fi Direct] or [WPS Connection] in [Direct]
(On the camera)
Connect the camera to a smartphone (→267)
(On your smartphone)
Start “Image App” (→228)
■
When connecting with [Manual Connection] in [Direct]
Perform step
2
(→229).
3
Select the device you wish to connect to
• When the connection is established, the confirmation screen for the transmission setting is
displayed. Check the setting and press [MENU/SET]. To change the send setting, press the
[DISP.] button. (→271)
4
Select [Single Select] or [Multi Select]
[Single Select]
Select the picture
Press [MENU/SET]
[Multi Select]
Select the picture (repeat)
• If selected again, the setting will be cancelled.
Select [OK]
• The number of pictures that can be sent by [Multi Select] is
limited.
2 3
4 5 6
1
OK
• A confirmation screen is displayed. If you select [Yes], the operation is executed.
• To change the send setting, press [DISP.] button.
• To close the connection, select [Exit].
To Next Page
Loading...
