64
SQW0038
Basics
Switching the display information on the recording screen
Enabling/disabling the histogram display
→ [Custom] → [Histogram] → [ON] / [OFF]
Use
to set the position.
Displays distribution of brightness in picture – e.g.
if the graph peaks at the right, this means there are
several bright areas in the picture. A peak in the centre
represents correct brightness (correct exposure). This
can be used as a reference for exposure correction, etc.
(Example)
Dark ← OK → Bright
●
When the histogram is not the same as that of the recorded picture under the following conditions,
histogram will be displayed in orange:
• When manual exposure assist indicates settings other than 0 EV in [Manual Exposure] Mode or
during Exposure Compensation.
• When the flash fires.
• When the correct exposure is not achieved or when the brightness of the screen cannot be
displayed accurately in a dark location.
●
The histogram displayed during recording is only a reference.
●
The histogram is different from those displayed using the image editing software of a computer.
To Next Page
Loading...
