91
SQW0038
Picture effects (Filter)
Taking pictures using picture effects (Filter)
Adjusting the picture effects according to your preferences
You can easily adjust the setting conditions (such as degree and colouring of an effect) of
the picture effects according to your preferences.
1
Press to display the setting screen
2
Turn the control dial to adjust the setting conditions of
the picture effects
• The settings that can be adjusted vary depending on the
selected picture effect. Refer to “Items that can be set” for the
corresponding picture effect.
• Press [MENU/SET] to return to the recording screen.
• When you select picture effects, [
] appears on the screen.
• If you do not want to change the current setting, select the centre
point (standard) in the adjustment level bar.
Taking two still pictures with and without picture effects
([Simultaneous record w/o filter])
You can take two still pictures at the same time by pressing the shutter button once; one
with effects and one without effects.
→ [Rec] → [Simultaneous record w/o filter]
Settings: [ON] / [OFF]
• When [ON] is set, the camera will take a still picture with the effects applied and then a still picture
without the effects.
• A still picture recorded without effects applied will use the same menu settings as when the picture
effects (Filter) were applied. The following settings are fixed.
– White Balance: [AWB] (You cannot perform fine adjustments.)
– [i.Dynamic]: [OFF]
• After taking the picture, [Auto Review] will display only the still picture with the effects applied.
●
If you set this function to [ON], burst, Auto Bracket, Aspect Bracket, White Balance Bracket, [Time
Lapse Shot], [Stop Motion Animation] and panorama picture recording will be disabled.
●
This function is disabled during motion picture recording.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
