Panasonic MINAS-A5B Series - Page 27

No. SX-DSV02472 -21-
The following figure shows the state flow of 7-segment LED.
Control power ON
All off
All on
[
n A ]( Station alias)
(approx.
0.6 s)
Setup of RSW(e.g. MSD
= 0, LSD = 3)
(Pn.7.01 The time specified by “Address display time
after powering
-on setting”)
Display of station alias
Normal display (when Pr 7.00 [LED display] is 0.)
Main power is ON and
ESM state is more than
PreOP.
Main power is OFF or
ESM state is Init.
Servo-ON
Servo-OFF
[
--]
[--] + right side dot is lit.
[00] + right side dot is lit.
Alarm occurred
Alarm cleared
Warning occurred
Latched: remove the cause and
clear alarm
Unlatched: remove the cause
Alarm display
Alternately blinks main and sub (with a dot at the left) of
the alarm code in decimal number.
(e.g. overload)
Warning display
Displays warning code (hexadecimal) and normal display
alternately at a slow rate. Right dot blinks when warning
code (Example of overload in servo-ON state) is
displayed.
Warning code (approx. 2 s)
Right dot blinks.
Main code
Sub code
(with left dot)
Normal display
(approx. 4
s)
R1.05
Motor Business Division, Appliances Company, Panasonic Corporation