Panasonic MINAS-A5B Series - Friction Torque Compensation

No. SX-DSV02472 -84-
5-2-12 Friction torque compensation
To reduce effect of friction represented by mechanical system, 2 types of friction torque compensation can be applied:
offset load compensation that cancels constant offset torque and the dynamic friction compensation that varies
direction as the operating direction varies.
(1) Applicable Range
□ This function can be applicable only when the following conditions are satisfied.
Conditions under which the Friction torque compensation is activated
Control mode
• Specific to individual functions. Refer to “Parameters” shown below.
Others • Should be in servo-on condition
• Parameters except for controls such as torque limit setup, are correctly set, assuring that the
motor can run smoothly.
(2) Parameters
Combine the following 3 parameters to setup appropriate friction torque compensation.
Class No.
At-
trib-
ute *1)
Title Range Unit Function
6 07 B
Torque
command
additional value
-100–100 %
Set up the offset load compensation value usually added to the
torque command in a control mode except for the torque control
mode.
6 08 B
Positive
direction torque
compensation
value
-100–100 %
Set up the dynamic friction compensation value to be added to the
torque command when forward positional command is fed.
6 09 B
Negative
direction torque
compensation
value
-100–100 %
Set up the dynamic friction compensation value to be added to the
torque command when negative direction positional command is
fed.
*1) For parameter attribute, refer to Section 9-1.
Note) CCW direction is positive.
R1.05
Motor Business Division, Appliances Company, Panasonic Corporation