Panasonic MINAS-A5B Series - Notch Filter

No. SX-DSV02472 -71-
5-2-6 Notch filter
In case of a low machine stiffness, you cannot set up a higher gain because vibration and noise occur due to oscillation
caused by axis distortion or other causes. By suppressing the resonance peak at the notch filter, higher gain can be
obtained or the level of vibration can be lowered.
1) Parameters
MINAS-A5B series feature 4 normal notch filters. You can adjust frequency and width and depth.
Class No.
At-
trib-
ute *1)
Title Range Unit Function
2 01 B
1st notch
frequency
50–5000 Hz
Set the center frequency of the 1st notch filter.
The notch filter function will be invalidated by setting up this paramete
r
to “5000”.
2 02 B
1st notch width
selection
0–20 —
Set the width of notch at the center frequency of the 1st notch filter.
2 03 B
1st notch depth
selection
0–99 —
Set the depth of notch at the center frequency of the 1st notch filter.
2 04 B
2nd notch
frequency
50–5000 Hz
Set the center frequency of the 2nd notch filter.
The notch filter function will be invalidated by setting up this parameter
to “5000”.
2 05 B
2nd notch width
selection
0–20 —
Set the width of notch at the center frequency of the 2nd notch filter.
2 06 B
2nd notch depth
selection
0–99 —
Set the depth of notch at the center frequency of the 2nd notch filter.
2 07 B
3rd notch
frequency
*2)
50–5000 Hz
Set the center frequency of the 3rd notch filter.
The notch filter function will
be invalidated by setting up this parameter
to “5000”.
2 08 B
3rd notch width
selection
*2)
0–20 —
Set the width of notch at the center frequency of the 3rd notch filter.
2 09 B
3rd notch depth
selection
*2)
0–99 —
Set the depth of notch at the center frequency of the 3rd notch filter.
2 10 B
4th notch
frequency
*2)
50–5000 Hz
Set the center frequency of the 4th notch filter.
The notch filter function will be invalidated by setting up this parameter
to “5000”.
2 11 B
4th notch width
selection
*2)
0–20 —
Set the width of notch at the center frequency of the 4th notch filter.
2 12 B
4th notch depth
selection
*2)
0–99 —
Set the depth of notch at the center frequency of the 4th notch filter.
*1) For parameter attribute, refer to Section 9-1.
*2) When the applicable filtering function is used, parameter value is automatically set.
2) How to use
Determine the resonant frequency by using the frequency response measurement function of the setup support
software, resonant frequency monitor or waveform graphics function and set it to the notch frequency.
R1.05
Motor Business Division, Appliances Company, Panasonic Corporation