No. SX-DSV02472 -68-
7 Position command exists • Valid for position and full-closed controls.
• Shift to the 2nd gain when the positional command was not 0 previously with
the 1st gain.
• Return to the 1st gain when the positional command was kept 0 previously
during delay time with the 2nd gain.
8 Not in positioning complete • Valid for position and full-closed controls.
• Shift to the 2nd gain when the positioning was not completed previously with
the 1st gain.
• Return to the 1st gain when the positioning was kept in completed condition
previously during delay time with the 2nd gain.
9 Actual speed is large • Valid for position and full-closed controls.
• Shift to the 2nd gain when the absolute value of the actual speed exceeded (level
+ hysteresis) (r/min) previously with the 1st gain.
• Return to the 1st gain when the absolute value of the actual speed was kept
below (level -hysteresis) (r/min) previously during delay time with the 2nd gain.
10 Position command exists +
Actual speed
• Valid for position and full-closed controls.
• Shift to the 2nd gain when the positional command was not 0 previously with
the 1st gain.
• Return to the 1st gain when the positional command was kept at 0 during the
delay time and the absolute value of actual speed was kept below
(level–hysteresis ) (r/min) previously with the 2nd gain.
R1.05
Motor Business Division, Appliances Company, Panasonic Corporation
To Next Page
Loading...
