Panasonic PT-FRQ50

Chapter 4 Settings — [PROJECTOR SETUP] menu
106 - ENGLISH
Setting [POWER MANAGEMENT]
Set the function to save power consumption when there is no input signal.
[NO SIGNAL LIGHTS-OUT]
This is a function to automatically turn o󰀨 the light source of the projector when there is no input signal for specic
period. The time until the light source is turned o󰀨 can be set.
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The
[ECO MANAGEMENT]
screen is displayed.
3) Press
as
to select [POWER MANAGEMENT].
4) Press the <ENTER> button.
f
The
[POWER MANAGEMENT]
screen is displayed.
5) Press
as
to select [NO SIGNAL LIGHTS-OUT].
6) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DISABLE]
Disables the no signal lights-out function.
[10SEC.] - [5MIN.]
Turns o󰀨 the light source when there is no input signal for the preset period.
Select [10SEC.], [20SEC.], [30SEC.], [1MIN.], [2MIN.], [3MIN.], or [5MIN.].
Note
f
The fan will rotate to cool the projector while the no signal lights-out function is operating and the light source is turned o󰀨. Also, the power
indicator <ON (G)/STANDBY (R)> blinks slowly in green.
f
When [NO SIGNAL LIGHTS-OUT] is set to anything other than [DISABLE], the following are the conditions to turn the light source back on
again from the condition that the light source has turned o󰀨 by this function.
g
When the signal is input
g
When on-screen display such as menu screen (OSD) or input guide, a test pattern, or a warning message is displayed
g
When the power <
v
/
b
> button is pressed
g
When the operation to disable the shutter function (shutter: opened) is performed, such as pressing the <SHUTTER> button
g
When the operating environment temperature is around 0 °C (32 °F) and the light source is forced to turn on due to warm-up
f
The no signal lights-out function is disabled in following cases.
g
When [BACK COLOR] is set to [DEFAULT LOGO] or [USER LOGO], and the Panasonic logo or the image registered by the user is
displayed in the projected image
[NO SIGNAL SHUT-OFF]
This is a function to automatically set the power of the projector to standby mode when there is no input signal for
specic period. The time before switching to standby can be set.
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The
[ECO MANAGEMENT]
screen is displayed.
3) Press
as
to select [POWER MANAGEMENT].
4) Press the <ENTER> button.
f
The
[POWER MANAGEMENT]
screen is displayed.
5) Press
as
to select [NO SIGNAL SHUT-OFF].
6) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DISABLE]
Disables the no signal shut-o󰀨 function.
[10MIN.] - [90MIN.]
Sets the time in increments of 10 minutes.