Panasonic PT-FRQ50

Chapter 2 Getting Started — Setting up
32 - ENGLISH
r
Angle sensor
The range of the installation attitude that is detected by the angle sensor built-in the projector is as follows.
30°
30°
Floor standing installation
Floor standing installation
Projection direction
Ceiling mount installation
Parts for installation (optional)
The projector can be installed on the ceiling by combining the optional Ceiling Mount Bracket (Model No.:
ET-PKD120H (for High Ceilings), ET-PKD120S (for Low Ceilings)) and Ceiling Mount Bracket (Model No.:
ET-PKD130B (Projector Mount Bracket)).
f
Be sure to use the Ceiling Mount Bracket specied for this projector.
f
Refer to the Installation Instructions of the Ceiling Mount Bracket when installing and setting up the projector.
Attention
f
To ensure projector performance and security, installation of the Ceiling Mount Bracket must be carried out by your dealer or a qualied
technician.
Projected image and throw distance
Install the projector referring to the projected image size, projection distance, etc.
Attention
f
Before setting up, read “Precautions for use” (
x
page 17).
f
Do not use the projector and the high-powered laser equipment in the same room. The DLP chips can be damaged if a laser beam hits the
projection lens surface.
Figure of projected image and throw distance
SD
L (LW/LT)
L (LW/LT)
SW SH
SH
SW
H
Projected image
Screen
Screen
Note
f
This illustration is prepared on the assumption that the projected image size and position have been aligned to t full in the screen.
f
This illustration is not in accurate scale.