Panasonic PT-FRQ50

Chapter 4 Settings — [PROJECTOR SETUP] menu
118 - ENGLISH
4) Press
qw
to switch the item.
[PROJECTOR]
Performs the RS-232C communication with the <SERIAL IN> terminal of the projector.
[DIGITAL LINK]
Performs the RS-232C communication via the optional DIGITAL LINK output supported device (Model
No.: ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK/LAN> terminal.
5) Press
as
to select [BAUDRATE].
6) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[9600]
Select the proper speed.
[19200]
[38400]
7) Press
as
to select [PARITY].
8) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NONE]
Select the parity condition.
[EVEN]
[ODD]
Note
f
When [INPUT SELECT] is set to [DIGITAL LINK], communication using that serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK/
LAN> terminal.
f
When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for “NO
SIGNAL SLEEP” of the DIGITAL LINK output supported device should be set to “OFF” to avoid interruption of communication.
f
The input communication speed is xed to 9 600 bps when [INPUT SELECT] is set to [DIGITAL LINK].
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1) Press
as
to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f
The
[FUNCTION BUTTON]
screen is displayed.
3) Press
as
to select a function.
[DISABLE]
Disables the <FUNCTION> button.
[SUB MEMORY]
Displays the sub memory list. (
x
page 131)
[SYSTEM SELECTOR]
Switches the [SYSTEM SELECTOR] setting. (
x
page 72)
[DAYLIGHT VIEW]
Switches the [DAYLIGHT VIEW] setting. (
x
page 70)
[FREEZE]
Temporarily pauses the image. (
x
page 100)
[WAVEFORM MONITOR]
Displays the waveform of the input signal. (
x
page 101)
[ASPECT]
Switches the aspect ratio of the image. (
x
page 74)
[PROJECTION METHOD]
Switches the [PROJECTION METHOD] setting. (
x
page 103)
[GEOMETRY]
Switches the [GEOMETRY] setting. (
x
page 76)
[OSD POSITION]
Switches the [OSD POSITION] setting. (
x
page 97)
4) Press the <ENTER> button.
Note
f
The
[FUNCTION BUTTON]
screen can also be displayed by holding down the <FUNCTION> button on the remote control.