Panasonic PT-FRQ50

Chapter 6 Maintenance — Self-diagnosis display
196 - ENGLISH
Self-diagnosis display
When an error or a warning occurs, a symbol for that is displayed in [SELF TEST] of the [PROJECTOR SETUP]
menu → [STATUS].
The following list shows the alphanumeric symbol that is displayed when an error or a warning has occurred and
its details. Conrm “Action number”, and follow the measure in “Measure for error and warning” (
x
page 196).
Error/warning alphanumeric symbol Error/warning alphanumeric symbol content Action number
U200 Intake air temperature warning 1
U201 Exhaust air temperature warning 2
U202 - U204 Other high temperature warnings 2
U280 Low temperature warning 3
U300 Intake air temperature error 1
U301 Exhaust air temperature error 2
U302 - U304 Other high temperature errors 2
U380 Low temperature error 3
F015 Luminance sensor error 5
F016 Angle sensor error 5
F017 QUAD PIXEL DRIVE unit error 5
F018 Air pressure sensor error 5
F061 Light source driver communication error 5
F086 Color wheel error 5
F111 Phosphor wheel error 5
F200 - F206 Fan warning 5
F300 - F306 Fan error 5
F400, F450, F500 Light source error 5
H001 Battery replacement for the internal clock 4
H011, H012, H013, H014, H016 Temperature sensor error 5
Note
f
The self-diagnosis display and the details of the malfunction may be di󰀨erent.
f
For errors and warnings that are not described in the table, consult your dealer.
r
Measure for error and warning
Action
number
Measure
1 The operating environment temperature is too high. Use the projector in an appropriate operating environment temperature
*1
.
2
The operating environment temperature is too high, or the exhaust vent may be blocked. Use the projector in an appropriate
operating environment temperature
*1
. Or remove any objects that are blocking the exhaust vent.
3 The operating environment temperature is too low. Use the projector in an appropriate operating environment temperature
*1
.
4 Battery replacement is required. Consult your dealer.
5 If the display does not clear after switching the main power o󰀨 and on, consult your dealer.
*1 For the operating environment temperature of the projector, refer to “Operating temperature” (
x
page 210).