Panasonic PT-FRQ50

Chapter 4 Settings — [NETWORK] menu
138 - ENGLISH
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ENABLE]
Select this item when the wireless LAN is to be used.
A device such as a smartphone can be directly connected to the projector even if a wireless LAN
access point is not set up separately because the projector is used as a simplied access point.
For setting procedure of the connection key, refer to “Setting the connection key” (
x
page 138).
[DISABLE]
Select this item when the wireless LAN is not to be used.
Note
f
[WIRELESS LAN] cannot be set if the optional Wireless Module (Model No.: AJ-WM50 Series) is not attached to the <USB (DC OUT)>
terminal.
f
Maximum number of devices that can be connected simultaneously to the projector via wireless LAN is four devices.
Setting the connection key
1) Press
as
to select [WIRELESS LAN].
2) Press
qw
to select [ENABLE].
3) Press the <ENTER> button.
f
The
[WIRELESS LAN]
screen is displayed.
4) Press
as
to select [KEY].
5) Press the <ENTER> button.
f
The
[KEY]
screen is displayed.
6) Press
asqw
to select the text, and press the <ENTER> button to enter the text.
f
The character string that can be registered as the connection key is as follows.
g
8 to 15 single-byte alphanumeric characters
7) After entering the connection key, press
asqw
to select [OK], and press the <ENTER> button.
8) Press
as
to select [STORE], and press the <ENTER> button.
f
The conrmation screen is displayed.
9) Press
qw
to select [OK], and press the <ENTER> button.
Note
f
The factory default setting of the connection key is “spjcxxxx”. xxxx is the four digit number assigned for each product.
[PROJECTOR NAME]
Change the projector name. Enter the host name if it is required to use a DHCP server.
1) Press
as
to select [PROJECTOR NAME].
2) Press the <ENTER> button.
f
The
[PROJECTOR NAME CHANGE]
screen is displayed.
3) Press
asqw
to select the text, and press the <ENTER> button to enter the text.
f
Up to 12 characters can be entered.
4) After entering the projector name, press
asqw
to select [OK], and press the <ENTER> button.
f
To cancel, select [CANCEL].
Note
f
The factory default setting of the projector name is “NAMExxxx”. xxxx is the four digit number assigned for each product.
[NETWORK STATUS]
Display the network information of the projector.
1) Press
as
to select [NETWORK STATUS].